Catalog

Tektronix 454A Oscilloscope With Operation and Service Manual CD-0
Tektronix 454A Oscilloscope With Operation and Service Manual CD-0
  1. Tektronix 454A Oscilloscope With Operation and Service Manual CD-0
  2. Tektronix 454A Oscilloscope With Operation and Service Manual CD-0

Tektronix 454A Oscilloscope With Operation and Service Manual CD

$199.00

Tektronix 454A Oscilloscope With Operation and Service Manual CD

This is a used item – normal wear and tear can be expected. It comes as shown in the picture and with an operation & service Manual CD for Tektronix 454A and R343A and a power cord, nothing else is included. It powers up and performs self-test, no other testing has been done. However, is is Guaranteed against DOA and has 30 day warranty under the terms and conditions stated.

Out of stock

SKU: Tektronix 454A Category:

Description

The Tektronix 454A Oscilloscope is a wide bandwidth, portable oscilloscope designed to perate in a wide range of environmental conditions.

  • The light weight and compact design of the 454A allow it to be easily transported, while providing the performance necessary for accurate high frequency measurements.
  • The dual-channel, DC0-t0-150 megahertz vertical system proves calibarted deflection factors fro 2 millivolts to 5 volts/division )bandwidth is reduced at the two lowest deflection factors).
  • Channels 1 and 2 can be cascaded using an external cable to provide a 400 microvolt minimum deflection factor.
  • A bandwidth limit switch allows low frequency, low-level signals to be viewed with reduced interference from signal above avout 20 megahertz.

  • The trigger circuits provide stable triggering over the full range of vertical bandwidth
  • Separate trigger controls are provided to select the desired triggering for the A and B sweeps
  • One of three sweep modes can be selected for A sweep; automatic triggering, normal triggering or single sweep.
  • The horizontal deflection system provides calibrated sweep rates from five seconds to 0.02 microsecond/division.
  • A X 10 magnifier allows each sweep rate to be increased 10 times to provide a maximum sweep rate of two nanoseconds/division in the .02 ohm position..
  • The delayed and mixed sweep features allow the B Sweep to be delayed a selected amount from the strt of A sweep to provide accurate relative-time measurements.
  • Calibrated X-Y measurements can be made with Channel 2 providing the vertical deflection and Channel 1 providing the horizontal deflection (TRIGGER swith set to CH 1 ONLY, HORIZ DISPLAY switch set to X-Y).

  • The regulated DC power supplies assure that instrument performance is not affected by variation in line voltage and frequency.

  • Total power consumption of the instrument is about 115 watts.

    • Related products